Toolwiz Inner Tie Rod Removal Tool Kit, 3/8'' Universal Low Profile Tool and Inner Tie Rod Hex Wrench Repair Remover 27-42mm End Wrench for 1/2" Square Drive, 2pcs for Most Cars Repair

Worked perfectly for me, better than the expensive ones. I torqued up to 100nm without issue on my VW Golf.I would recommend using a cable tie to apply pre tension as it will save a lot of time aligning up and messing it up.

One is quite big, too big for Renault Laguna, the other works but is awkward to use. But does work quite well.

Good product

So I purchased these to change both inner tie rods on a 1997 Fiat Ducato motorhome which were completely seized on. I tried the U shaped one first with a long extension and just get slipping and eventually rounded up the square ratchet hole.I then tried the other design where as, the more pressure you apply to undo it the more it grips and again with a really long extension bar and large ratchet it broke lose with a loud pop. So basically depending on how seized they are you might get away with the U shaped one if not the other one will almost definitely brake it loose.I use the same one I used to remove the tie rod as I did to tighten the new ones. You obviously just have to reverse it round the other way.Seem well made apart from the rounding of the square hole in the U shaped one but this could have been partly my fault for not checking if the extension bar was seated perfectly in the hole.

Not a very good option !

Broke on first go

Good quality tool and perfect for the job