Spicer5-760X U-Joint Kit 1310WJ Series (ISR)

Good quality U joint. I installed on my TJ Rubicon front right axel shaft, the old one was not doing so good. It's been a few years in use and it has withstood the abuse from the trails and and miles on road. Still feels solid.

This fit my 98 XJ with the Dana 30. They’re the Spicer U-Joints so there’s nothing bad to say! (I don’t know if their quality has gone down since the XJ’s were made or not but regardless I chose something decent because I DO NOT wanna do this job again lol) I recommend that you DO NOT install with a press (install with a ball peen hammer if you have one) and install with only one of the two corresponding caps on if that makes sense. I tried it with a press and crushed the seals AND the joint pushed needle out of place so I have to buy a new u-joint for the other side, still cheaper than if I paid a mechanic and now I know something! This is not an exhaustive install guide and there are tips I haven’t mentioned but remember to beat them with your hammer to seat the joints in place so that they move more freely. For what it’s worth the wheel hub stud part (removable from the shaft) had slightly more resistance — that may be an install error but it’s a note in case anyone else was curious so if I installed correctly there is supposed to be slightly more resistance where I mentioned.

Used in Dodge Ram 1500 Sport 4x4. Good fit and finish. Fit as it should. No complaints at all. Unsure of durability at this point.

Front axle u joint failed after 19 years. Jeep Wrangker uses Spicer, so I went with this again. Repair went as expected & axle functions fine once again. Box states made in USA, so quality, design & performance are top notch. Would highly recommend this product.

Easy to install. Good product

Good product, But they send it with the wrong hold clips. C type is the 1s I need for my jeep. Not some clip that goes on the outside of the bearing cap. They may be easier but will not work on my old jeep. Thanks I order another so I hope they send the1s in the picture.

Good replacement to my jeep xj front axle shift. It helped in tightening out everything. Good buy.

Spicer makes quality U-joints, but the Amazon fitment function is incorrect in this case. I have a 1994 Jeep Cherokee 4x4, and this u-joint was too big for the front axle. I gave it 5 stars, because it's a good U-joint... but I'd give Amazon ZERO stars on their fitment app. I returned the second one I got (for one side), but couldn't return the other, as I had ordered it some time ago. I do believe it may fit one of my drivelines however, but further research is needed. Just beware, and make sure the bearing caps are the right size. In my case, that was (1.0625" = 1 1/16"). As a final note, it may also be a function of which front axle you have.