SoloGood2S-8S Lipo 6-36V UBEC-8A BEC 5.2V/6.0V/7.4V/8.4V Servo Independent Power Supply Suitable for RC Sutomotive Fixed Wing Aircraft Robotic Arms black

I stuck this in a very old onroad touring car to run a more powerful servo than the BEC could provide. Hooked it up to old servo and tested, voltage was what it should be at each jump and it handled the stall amperage(6A) of the new servo without getting hot at all. I ran the car for a half hour at 6v and it was still just warm. I will be moving to 8.4v soon and I will update this review when I have more to share.Update: 8.4v works, it even boosts from 7.2v nimh. And it doesn't even get hot!

Hooked everything up. Double checked it was all correct. Powered by a 3s lipo, set bec to 8.4v, receiver rated to 9.6v input. Made sure positive wire on esc throttle plug was removed. Powered on the bec and everything worked great for 5 seconds and then my brand new $60+ receiver stopped working and the car went into fail safe mode. Needless to say, I'm pretty upset.Also, this is the biggest bec I've ever seen. It doesn't even come close to fitting in the receiver box and it doesn't look to be water proof at all.

It eorks its definitely wired kinda weird i rewired it but its huge and it works but save some money and get a castle bec

Direct wired to battery running 8.4v and so far no issues

Installed in my Trex 600 heli, straight hook up to 6s 5000mah and performing well. lets hope it stays that way. about 14 flights so far, dose not get hot, barely warm.