Sliding Patio Door Handle Set with Key Cylinder and Mortise Lock, Full Replacement Handle Lock Set Fits Door Thickness from 1-1/2" to 1-3/4", 3-15/16” Screw Hole Spacing, Reversible Design(Non-Handed)

Seems like similar quality paint and finish to the original. Less than 5 min install. Originally tried to use the same hardware but this is a slightly thicker screw. Thankfully it comes with 3 sizes depending on the thickness of your slider.Shortening the stem was a little tricky. It’s soft enough to bend at the relief cuts but I almost cut it too short bc it’s hard to control. It might just be easier to take a dremel or electrical cutters to it.

It is what I am looking for ( my patio door frame width 1.5 inch). The menu is notoriously short - have to do mind storming myself. In overall a good product that you can not find at home depot

Will not fit returned

This handle/lock set fit my door well. I didn’t even have to change out the latch part. Once installed, it worked smoothly and has a sturdy feel to it. The installation does require some cutting of the flat, metal pieces that engage with the latch assembly. They are too long, likely to accommodate thicker doors so I’m sure it will need to be cut regardless of the type of door you have. I put the lever on one side and the lock set on the outside as they would be installed. Then I marked them both where they intersected in the middle. The idea is to cut them so they both engage the latch assembly. Cut them too short and one or both will not engage the latch assembly. Cut them too long and they will either not fully tighten down or will bind (or both) as they butt up against each other in the center.Once marked, I put them in a vice and cut with a dremel tool (as others have mentioned). If no dremel, a pair of clamping pliers and a hack saw will work too. It will be more of a challenge hold them while cutting though. Once cut to length, the rest is pretty simple. You may want to file off the burrs after cutting.It works great once installed. Key is smooth as is the latch engagement.I have been using it for a couple weeks now and no issues. I will update if anything changes.

works well