solder wick braid 10ft Length Desoldering Wick Braid Remover Tool Solder Sucker 1 piece No-Clean soldering Wick Wire Roll and Disassemble Electrical Components

This generous 10' length of wick works well to quickly and easily remove solder from your electronics for repairs and rework. The wick is thin, so it can get into tight areas, yet holds its shape where placed without drooping, and the wicking action is near insan even with little heat. The color change is very visible when saturated with solder so you know when to move to another section of wick. The wick is strong and also cuts easily with a scissors leaving no loose strands or sharp edges. Great addition to plunger or bulb suction tools for when larger areas or gentler solder removal is required.

This is a pretty basic product - finely braided copper mesh that wicks up hot solder. It did exactly what it needed to. Make sure your soldering iron tip is very clean so it transfers heat quickly through the wick, and make sure it's hot enough to quickly melt the solder. Use repeated short applications of heat. Switch to a new section of wick often. The wick may stick to the board if there's a solder bond between them - don't pull it loose since it might leave some little wire strands behind, just add another touch of heat until the solder is melted and pull the wick loose. Then switch to a new section of wick. It took me some trial and error but in the end it got the job done.

Very useful it helped clean solder as it described and worked perfectly

Picture looks like it is a big roll. Smaller than I thought. I haven’t rolled it out but I think it is ok

If you solder a lot or less often, this help to keep your work nice and clean

Worked as expected. As a first-time solder remover it would have been nice to have had helpful hints on use.

Have not used it yet, but sure it should perform as expected.

Bought thisnfor soldering electronics. Fixed my PS5 with it. Great product works like it should. Thanks!!